Drag the model to turn it around at any step.
Choose the guide you need.

Turn the tabletop upright

DRAG TO ROTATE
Preparing your 3D model…
TV / TOP↑seated side below
Drag to rotate · Scroll to zoom · Right-drag to pan
Optional display settings

Room reference

Room reference photo

Check against the real room.

Courtroom set up, seen from the entrance: bar table and lectern near the TV, solicitor table in the middle of the room
Facing the TV
Courtroom set up, seen from the entrance, a little further right
Facing the TV
Courtroom set up, seen from the doorway
From the doorway
Courtroom set up, seen from behind the bar table looking toward the doors
Looking toward the doors
Courtroom set up, seen from behind the bar table, a little further right
Looking toward the doors

Conference restoration

The new conference guide is separate from courtroom setup. END1 and END2 show the required finished layout. Lock the front and middle pairs at their TV-facing top edges, link those pairs on the left and right, lock the rear pair at top and bottom, then link it to the middle pair. No handwritten order sheet was identifiable in the uploads; this sequence follows your detailed front/middle/rear locking correction. Keep the table approximately 42.5cm from the fixed-book right wall as entering. Screen controller uses the white-tape port (e.g. A11); microphone uses the white-tape port in the other box. Photo-based hole/device placements are shown in conference mode; use the photos for exact physical matching.

Restore immediately after court use. Doors always open for fresh air; AC16°C; clean/tidy at all times; remote below TV; lectern and spare cables cupboard. Every booking requires COLD water and clean glasses.

Updated courtroom instructions

  1. Unplug equipment from the floor boxes and put removable equipment aside. The microphone cannot be moved; ensure it is unplugged. Press the handle underneath each table and rotate it upright.
  2. Arrange before locking: use the cupboard tape measure, position the bar 116cm from the front wall and against the bookcase on the right, keeping a walkway to the left. B4 holds the Cisco AVL controller. The solicitor table goes 175cm from the back of the bar and 77cm from the bookcase on the right, over the floor box; R1 is furthest from the TV, R2 nearer. R2 has the secondary microphone; R1 has the blank cable hole.
  3. Lock the bar's left/right SHORT EDGES first, then remaining middle/underneath interlocks and the solicitor table.
  4. Put the desktop lectern between B3 and B4 with its reading side facing the seated person looking toward the TV. Keep its reading side facing the seated person.
  5. Put equipment back: controller on bar uses white-tape port; microphone on solicitor table uses the white-tape port in the other floor box. Run cables through the holes and close the floor boxes.

Model details

The two modes share the approved restoration table and device construction. The courtroom uses four bar tables and two solicitor tables, three existing holes, the controller and the microphone. The bar floor box retains the approved position; the solicitor floor box is underneath the middle of the solicitor table. The B4 controller-hole location is retained. The bar is 116cm from the front wall; the solicitor table is 175cm behind the bar and 77cm from the right-hand bookcase. Each table is1500×750×740mm; room, furniture, hole offsets and hardware dimensions remain illustrative.

Table IDs lie inside each tabletop and move with its pivot. Device and lock callouts follow their objects. R1 is furthest from the TV. Use existing holes; no furniture modification is instructed. The desktop lectern is not a floor-standing stand.

Source: supplied PDF, room photographs and room-specific user corrections.